FLEXLAB pushbuttons from the RAFIX 22 FS series by RAFI can be individually labeled and allow mechanical engineers to reduce time for planning or making customization to operating devices.
Thanks to the option of subsequently labeling the FLEXLAB pushbutton, function assignments relevant to the target application need notbe taken into consideration too early, but can be carried out at a convenient later time – including by the end customer. The flexible identification system also allows for the correct and appropriate placement of the label if the control panels or individual control units have to be mounted in an order that, due to changes in mounting conditions, diverges from the plans.
RAFI offers DIN A4 labeling sheets with pre-cut labels that are suitable for the basr unit of the FLEXLAB pushbutton and can be printed with any conventional office printers. After the labeling inserts are printed, the labels can simply be detached from the sheet and inserted into the exchangeable lens using the fine stop tabs. The lenses are optionally available in colorless, red, yellow and green designs and have a small raised tactile dot located at 12 o'clock, making them easier to insert and snap into the desired direction.
The FLEXLAB pushbuttons reach IP 65 protection class, are illuminated and available with latching or momentary functions. RAFI offers the buttons for a mounting size of 30 x 30 mm with square or round collars. Depending on wether the buttons are combined with PCB contact blocks for printed circuit board applications or with QC contact blocks for wiring, the mounting depth is 9.2 mm or 27 mm behind the front plate.